Multiple codes present, P0301, P0441, P0455, P0171, P0174, during testing the charcoal canister filter plastic broke, replacement will be needed, at this time recommend the purge valve and gas cap be replaced, clear codes and test drive to set emissions monitor. Additional repairs may be needed…
Battery tested weak, terminals have corrosion. Replace battery and clean terminals
Lucille L. gave our service a 5 star review on 8/23/2024
Engine Asse- Remove & Replace – LS,LT,LTZ,4WD – [Includes: R&I Front Propeller Shaft. Includes: R&I Radiator. Includes: R&I Air Conditioning Condenser; recover, evacuate and recharge Air Conditioning System.]
Drive belts worn. Radiator beginning to seep coolant from the side tank. Passenger fuel injector rail not sealing, tube is tweaked, common failure on these models when rails need to be removed. During road testing a CEL set for bank 2 sensor 2 failure, oxygen sensor not functioning properly.
Replace driver side turn signal bulb, notification on IPC came on while driving.
Carl C. gave our service a 5 star review on 8/21/2024
Multiple codes present, P0133, P0153, monitor system operation, both front oxygen sensors appear to be sluggish, sensors appear to have been replaced, they look newer than the rear sensors, suspect a faulty MAF sensor causing sensor performance to be off, install new MAF sensor and monitor. VCS, VES light on and a code is present for "zero point calibration not performed", further inspection found PCM updates required to perform zero point calibration, update PCM to newest version and perform zero point calibration.
Add fuel to the vehicle for road testing
Perform headlamp restoration
TPMS light on
Ladi S. gave our service a 5 star review on 8/13/2024
Inspect exterior lens condition and exterior bulb operation
Lubricate chassis if applicable
Tire condition and is rotation recommend? Next service
Dried coolant on the oil pan, water pump beginning to seep, replacement will be needed soon. Battery terminal corrosion. Passenger upper ball joint boot torn open, possible upgrade needed to control arms due to leveling kit that was installed to correct ball joint angle. Rear leaf spring bushing dry rotted.
Lucas A. gave our service a 5 star review on 8/7/2024
Road test vehicle to isolate noise, abnormal bearing noise appears to be coming from the passenger wheel bearing, sold as a hub assembly, recommend tear down to inspect and replace wheel hub.
**** SEE RECOMMENDATION SECTION FOR NOTES ****
Jim L. gave our service a 5 star review on 7/16/2024